Ashley-Edison M2 Uživatelský manuál stáhnout pdf (Strana 19)

ASHLEY-EDISON (UK)

Manufacturers of Voltage Stabilisers – Power Conditioners – Constant Voltage Compensators – Variable Transformers

OSES THREE PHASE OPERATOR MANUAL - EN

Issue No: AE/OSES-3P/TP/07/2011

- Page 19 of 37-

9. OUTPUT VOLTAGE ADJUSTMENT

9.1 INTRODUCTION

The Stabiliser will normally be supplied factory pre-set for the voltage requested at

time of ordering. Should the output voltage be required to be adjusted / recalibrated

this can be achieved by adjusting the settings on the Servo Amplifier PCB.

It should be noted that as a general rule for H, HD, LY & LD series models the

permissible input voltage swing is stated relative to the set output voltage.

WARNING!

Adjusting the Output Voltage should only be carried out by duly

qualified personnel.

The Stabiliser can contain potentially dangerous and life

threatening voltages – up to 600 V AC. Use extreme caution when

opening the covers and do not leave the unit unattended with the

doors open or covers off.

9.2 VOLTAGE ADJUSTMENT PROCEDURE

• Altering the output voltage on the stabiliser is done by adjusting a screwdriver

slotted potentiometer on the Servo Amplifier PCB (see below).

• The three pots (one per phase) are clearly marked on the board - ‘VR1’, ’VR2’,

‘VR3’.

‘VR1’

L1 phase

‘VR2’

L2 phase

‘VR3’

L3 phase

OUTPUT VOLTAGE ADJUSTMENT

LED

Indicators

PROTECTION DIP

SWITCH

“SW1”

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 36 37

Žádné komentáře

Ashley-Edison M2 Uživatelský manuál Strana 19